7 Simple Ways to Tile a Fiberglass Pool

7 Simple Ways to Tile a Fiberglass Pool

Do you want to make your fibreglass pool look more eye-catching? Then you have to tile it. Having in mind that you may consider it is challenging to go by yourself, we offer you the best solution. A solution that will make your fibreglass look appealing to the eyes. Here is the best and the simplest way to go about it.

Step1: Assemble all the tools and equipment’s needed.

In any construction work, assembling all the tools and equipment’s is always your first step. Assembling tools makes sure that they are available for you to carry out your work without straining. Here are some tools that you may need when tiling your fibreglass pool.

Ø Tape measure

Ø Bucket

Ø A pencil

Ø Scissors

Ø Dishwashing liquid

Ø Silicone rubber tile adhesive

Ø Silicone rubber pool tile grout

Ø Nylon scrubbing sheet

Ø Caulk gun.

Ø Gloat float.

These tools will make sure that you carry out your work simultaneously.

Step2: Prepare the fibreglass pool

This involves draining the pool to the level where you will start tilling. It may be done manually by opening the outlet pipe of the fibreglass pool or mechanically by use of centrifugal pump. Using a shoe is more efficient as the desired level of water is easily attained. After the water is drained, it then dried up any water element.

Step3: Measure the size of the pool

The size of the pool is taken by use of a tape measure. You should be accurate as possible for a proper workout. The measurements will help you to know the number of tiles needed for the pool. You should make sure that the size of the tiles is even. Uneven tiles should be trimmed off using a wet saw. Glass tile for this type of project comes in sheets connected by wire mesh.

Step4: Apply adhesive

Cut off the tip of a tube of silicone rubber pool tile adhesive with a utility knife. Push the rod on the side of a caulk gun into the silicone tube nozzle, piercing the tube`s internal seal. Fit the silicone adhesive into the caulk gun. Squeeze zig-zagging lines of silicone adhesive over the backside of the sheet tiles. Numerous thin lines of adhesive are better than a few thick lines.

Step5: Place the glass tiles in the pool

Press the tiles against the edges of the pool. Begin on one side of the pool to the other sides. You should be cautious as much as possible for proper aligning. Pencil line drawn lines should help you to fix the tiles. If the tiles do not fit the space between the last fixed tile and the edge of the skimmer, you will need to adjust the grout lines of these last tiles slightly. Cut the mesh sheet with scissors to separate the tiles, then glue and install the tiles individually until you reach the skimmer. Let the tiles dry for about 40 to 50 minutes.

Step6: Grouting

Open and prepare a tube of silicone grout as you prepared the adhesive. Squeeze a generous amount of silicone grout onto the tiles, then spread it over the tiles. Drag the edge of the float over the tiles to remove excess grout. Return to the starting point and scrub the tiles with a nylon scrubber dipped in a bucket of soapy water. Let the tiles dry for 40 minutes, then wipe each tile with a rag.

Step7: Finishing touches

Wash the tiles with detergent and dry them with a dry piece of cotton cloth. It would be best if you were more cautious as the tiles are slippery. Upon cleaning and drying you then supposed to leave the pool to dry for 3hours. Afterwards, you can fill the pool with water.

After you follow all these steps, your fibreglass pool will be more attractive. If it`s for commercial use, more customers will be attracted to your pool. Tiling your pool will be that simple. Make it happen.