How To Install A Tap
Traditionally, it was tough for someone to install taps. This is because they had a lot of requirements and knowledge. Tap installation today is effortless and does not require a lot of things. Getting a tap installation service is also very easy as well. Some taps can be installed from the top in such a way that you do not have to crawl down, trying to do the installation.
Are you looking for some tap installation tips? Then you are on the right platform because Tap and Faucet City Singapore offer you the best advice when it comes to tap installation. You must know the essential tips to have a free leak tap installation. Below are some of the best tips that will help you install that kitchen tap you would wish to install.
Cut out the old faucet
The nuts joining the faucets together can be very hard to remove. It will take a lot of strength and time to remove these nuts from the faucet. If you wouldn’t mind, just break the nuts so that you do not spend a lot of time removing them. There are three types of tools you can use for this. Don't use plagiarised sources.Get your custom essay just from $11/page
The rotary tool: this has a cutting disc. It is used to cut metal. It will help you when cutting the nuts.
Oscillating tool: this has a metal cutting blade. It will also help cut the nuts.
A screwdriver: this will be needed to 5remove out the nut from the faucet body.
If there are any other stubborn parts, you can always cut them off. The pop-up drain especially can be very stubborn. Instead of wasting your time trying to remove it, it’s better to cut it off.
Mount the faucet with silicone
Silicone is trusted when it comes to joining metal parts together. If you do not join the faucet properly with silicone, water can quickly get under the faucet. If water gets under the faucet, it may damage your cabinet or countertop, especially during the bathroom tap installation. Imagine having your kitchen cabinet having stains due to a leaking tap, which is wrong, right? Using silicon will ensure that it is properly fixed and that there are no leakages. It will also ensure that the faucet will not move around the tap. It holds it firmly into place; it is, therefore, not easy for the faucet to break. Remember, you should wipe off any excess silicone that might have dripped out using a paper towel followed by mineral spirits, maybe.
Check and upgrade the supply lines
This might be the hardest part of the kitchen tap installation. The supply lines need to be properly fixed so that there are no leakages. The old supply lines were way cheaper but very difficult when it comes to installation. The modern supply lines might be expensive, but they are worth the amount of money you buy them. This is because they are not as hectic as the old ones. A properly screwed nut achieves an effective seal. The old supply lines will mess your head up. Also, ensure that you measure the supply lines. Measure the underside to determine the length of the supply lines. If the supply lines you bought with the faucets are not enough, you can buy extensions.
Check the stuck off valves
If the valves are loose, you should tighten them again. It will help an easy time when turning the valve. After this is done, and the valves are working correctly, remove the aerator before turning on the water.
Check for leaks
After you are done with the tap installation, and you are sure that everything is working. Check for any leaks that might be there. Please turn on the water and let it run for about three minutes. As you do this, ensure that you have dried every joint so that you can easily notice any leakages. This is because any wet spot will be more precise.
If you are looking forward to buying taps and also getting tap installation service, do not worry as we are here for you. We offer only but the best when it comes to taps and services. No need to worry, try us and smile all the way to your new taps each time you turn them on.