What is a dual bevel miter saw?
The standard miter saw can cut at the straight angles of 90 degrees. This compound miter saw came as a solution which facilitates the miter saw to rotate and tilt sideways to ensure angles and bevel cuts at the same time. If you are using a typical compound miter saw, you must come across the issue of flipping the saw to ensure end to end cut from the right position.
If you are using a dual bevel miter saw, it can tilt to both left and right to allow you to bevel in both directions. You do not need to flip while tilting from one side to other.
A dual bevel miter saw is widely used to design a crown moulding. A bevel tilts easily to the 33.9 degrees against the 31.6 degrees of the typical mitre saw. You are not required to flip the moulding to 180 degree to cut its other end.
You can easily make the first cut and slide the moulding to cut the opposite direction without flipping the moulding. You can easily cut the furniture legs, and braces with a dual-level miter saw quickly.
What is a difference between a miter cut and a bevel cut?
A cut along the width of material for an angle other than 90 degrees is generally a miter cut. These cuts are measured concerning a square cut.
A bevel cut includes the cutting of a workpiece other than 90 degrees along with its thickness. The angle is generally no measured against the face of the square-edge cut.
For a miter cut, the blade is angled through the horizontal plane of the workpiece while for a bevel cut, the blade is angled via vertical plane.
Let’s discuss the various benefits of dual miter level saw:
Cost Analysis
However, the double bevel miter saw is expensive than the single bevel miter saw. But the efficiency and convenience offered by the dual bevel miter saw is manifolds. If you deal with the crown moulding frequently as a DIY user, you must refer the dual-level miter saw.
Dealing with complex angles
A double-level miter saw is the best option to reach the complex angles. Compared to the standard counterparts, dual-bevel miter saw are advanced to cut the compound aspects. While a conventional miter saw can cut at 31.6 degrees, a dual-bevel miter saw can make an angle cut at 33.9 degrees.
Low angle accommodation
A bevel miter saw comes along a V-shaped cutout so that the small angles can be accommodated on each side of the blade. When it comes to the single-bevel miter saw, there is an angled end at the left side fencing of the blade.
As you are not required to flip your workpiece over, dual-level meter helps you to save money and considerable time. These are appropriate to use for handcrafts and custom trims. However, it can be used appropriately by an experienced artisan and not meant for the rookie.